Alvin Parallel Straightedge 1101 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro ne Alvin Parallel Straightedge 1101. Alvin Parallel Straightedge 1101 User's Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 4
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Parallel Straightedge Assembly Instructions
For Models 1101 and 2201
Figure 1
B
A
C C
Rear Wire Connectors
Front Wire Connectors
1. Verify that all parts shown in parts list are included.
2. Check that drawing board has a solid outer frame to hold screws and that it is not warped.
Alvin straightedges will not work properly on warped boards.
3. Position front and rear wire connectors on top of drawing board as shown in Figure 1.
Use chart below to determine proper spacing. Center the straightedge on the board.
For Straightedge Length Dimension A Dimension B Dimension C
30" 27¾" 28¾" ¾"
36" 33¾" 34¾" ¾"
42" 39¾" 40¾" ¾"
48" 45¾" 46¾" ¾"
60" 57¾" 58¾" ¾"
Proceed to step 4 on next page.
Tools Required:
Phillips screwdriver and
1
16
" drill or awl
Straightedge with Wire and Spring (1)
Front Wire Connectors (2)
Right Rear
Wire Connector
(1)
Left Rear
Wire Connector
(1)
Rear Pulleys
(2)
Rear Brake
Knob
(1)
1/2" Brake
Stud Screw
(1)
3/4"
Screws*
(6)
5/8"
Screws*
(2)
3/8"
Washers
(2)
To assemble, follow step-by-step instructions below:
wire
*NOTE: Only six screws total are required for installation. We have included
two extra screws to accomodate various board thicknesses.
Parts List
Zobrazit stránku 0
1 2 3 4

Shrnutí obsahu

Strany 1 - For Models 1101 and 2201

Parallel Straightedge Assembly InstructionsFor Models 1101 and 2201Figure 1BAC CRear Wire ConnectorsFront Wire Connectors1. Verify that all parts sho

Strany 2 - If your board is

Figure 5Figure 6Stretch spring to 2½" in length for proper tensionFigure 2 Figure 3Figure 4¾" Screw¾" Screw*¾" Screw½" Br

Strany 3 - REWIRING INSTRUCTIONS

ADJUSTMENTSTo Adjust Parallel Position: 1. Be sure all three brake knobs are free and loose. (See Figure 5 on previous page for brake locations.)2.

Strany 4 - ALVIN Replacement Parts

A6333 10/06Contains:2 Front wire connectors2 Rear pulley assemblies8 Screws (6x 3⁄4" and 2x 5⁄8")Wire not included and must be ordered separ

Komentáře k této Příručce

Žádné komentáře